- Email: [email protected]
- Phone: +62 21 3114 1058
What We Do
Engineering
We at PT Prima Era Mitra, offer a comprehensive range of engineering services (e.g., Process Design & Performance Guarantee, Mechanical Design, Project Service, Local Regulation, Mechanical & Performance Commissioning, and QC & Inscpection) to meet the needs of modern businesses. Our team of highly skilled and experienced engineers is dedicated to providing innovative solutions that are tailored to your specific requirements.
Process Engineering for Oil & Gas
Engineering for Design
Project Exection
Commissioning
Process Engineering for Oil & Gas
Oil & Gas Separation Process Design & Performance Guarantee
- Oil & Gas Coalescing Coalescence is the process of causing an agglomeration of liquid aerosols to form larger droplets which are large enough to be drained away gravitationally
- 3 Phase Separator A three-phase separator uses gravity to separate produced well fluid into gas, oil, and water phases. Installation of these vessels occurs near the wellhead, and they come in horizontal and vertical configurations.
- Test Separator A test Separator is a vessel that is used to separate and measure small amounts of oil and gas. with gas and liquid flowmeters often provided for periodic measurement of the production rate from individual wells or groups of wells.
- Production Separator A pressure vessel that is used for separating the fluid components of an oil and gas well stream into both gaseous and liquid constituents. The separators can be installed in either an onshore processing facility or on an offshore platform.
- Gas Sweetening CO2 – H2S Removal is the process for the removal of mainly acid gases (H2S and CO2) and, in addition, the simultaneous removal of sulfur organic species (RSH, COS, CS2) from the process gas. It is an essential step of sour gas processing for natural gas treatment, NGL recovery, LNGs, refineries, and petrochemicals to meet transport and market specifications, comply with environmental regulations for emissions, and control corrosion.
- Crude Oil Dehydrator The removal of water or water vapor from crude oil, by separating the oil from the water, often in a rotating centrifuge. Crude oil contains water that must be removed to levels that meet pipeline specifications before refining into upgraded petroleum products.
- Crude Oil Desalting The first refining process applied to crude oil. The process removes salt, water, and solid particles that would otherwise lead to operational problems during refining such as corrosion, fouling of equipment, or poisoning of catalysts.
- Water Treatment: Hydro cyclone Cyclone separators are used to remove liquid and solid impurity substances in gas or liquid streams. The method can also be used to separate fine droplets of liquid from a gaseous stream.
Engineering for Design
Process Design
- PFD / P&ID / Heat Material Balance Sheet
- Process Basic Mechanical Design
- Process Basic Data Sheet ( Mechanical & E&I)
- Fabrication Assembly & General
- Fabrication Detail
- Piping & Support
- Construction Structure
- Electrical & Instrument Data Sheet
- DCS / PLC / MCC
- Control Panel
Project Exection
Own Project
- Project Management & Coordination
- Schedule Control Responsibility
- Quality Control Responsibility
- ITB & RFQ Create
- Supplier Audit
- Vendor & Supplier Selection Advise
- Vendor Quotation Evaluation
- Local Project & Coordination
- Technical Review
- Schedule and Quality Control
- Project Document Handling
Commissioning
Mechanical Commissioning
- HAZOP Evaluation
- Mechanical Sequence and Function Check
- Mechanical Trouble Countermeasure
- System Leakage Check
- Operational Check
- Cold Circulation / Hot Circulation
- Performance Evaluation
- Performance Trouble Countermeasure
- Operator Training
Let’s discuss about how we can help make your business better
Other Services
PT PRIMA ERA MITRA
We offer a comprehensive and on-demand service that integrates a wide range of Engineering, Procurement, Fabrication, and Construction Services as well as General Trading
